Advertisement
SERVICE AND ADJUSTMENTS
FIG. 33
FRONT WHEEL
TOE-IN/CAMBER
Your new tractor front wheel toe-in and camber is set at the
factory and is normal. The front wheel toe-in and camber
are not adjustable.
If damage has occurred to affect the
factory set front wheel toe-in or camber, contact a qualified
service center,
TO REMOVE
WHEEL
FOR REPAIRS
(See
Fig.
34)
•
Block up axle securely.
•
Remove axle cover, retaining ring and washers to allow
wheel removal (rear wheel contains a square key - Do
not lose),
•
Repair tire and reassemble,
•
On rear wheels only: align grooves in rear wheel hub
and axle, Insert square key,
•
Replace washers and snap retaining ring securely in
axle groove,
•
Replace axle cover,
NOTE: To seal tire punctures and prevent flat tires due to
slow leaks, tire sealant may be purchased from your local
parts dealer, Tire sealant also prevents tire dry rot and
corrosion,
WASHERS
RETAINING
AXLE COVER
SQUARE KEY(REARA_R_.__.._ _l
WHEELONLY)
FIG. 34
TO START ENGINE
WITH A WEAK
BATTERY
'See Fig. 35)
WARNING:
Lead=acid
batteries
gen=
crate
explosive
gases.
Keep
sparks,
flame
and smoking
materials
away from
batteries,
Always
wear
eye protection
when
around
batteries.
If your battery is too weak to start the engine, it should be
recharged, (See "BATTERY" in the MAINTENANCE
sec-
tion of this manual),
If "jumper cables" are used for emergency starting, follow
this procedure:
IMPORTANT: YOURTRACTOR IS EQUIPPEDWITHA 12VOLT
SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT
SYSTEM. DO NOT USEYOURTRACTOR BATTERYTO START
OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
•
Connect one end of the RED cable to the POSITIVE
(+) terminal of each battery(A-B), taking care not to
short against tractor chassis.
•
Connect one end ofthe BLACKcableto
the NEGATIVE
(-) terminal (C) of fully charged battery,
•
Connect the other end of the BLACK cable (D) to good
chassis ground, away from fuel tank and battery,
TO REMOVE CABLES, REVERSE ORDER -
•
BLACK cable first from chassis and then from the fully
charged battery,
•
RED cable last from both batteries,
WEAK OR DEAD
FULLY CHARGED
BATTERY
BATTERY
FIG. 35
24
Advertisement
