Hoover Twin Chamber Service Instructions Manual page 6

3. Once the Lower Handle has been removed from the
base of cleaner the Attachment Cord can be lifted out of
Lower Handle and replaced.
Note: The attachment cord has a small bump located on
the end of the plug. This prevents the cord from easily
sliding out of the Lower Handle.
G. Final Filter I Final Filter Grille
1. The Final Filter Grille can be removed by unsnapping
the grille from the hinges on the Dirt Cup Housing.
2. The Final Filter is placed into the holder with the green
side of the filter facing outward.
G. Front Cover
1. The Front Cover is replaced by removing the 2 screws
as illustrated below. Once the screws are removed the
Front Cover can be lifted off of the Dirt Cup Housing.
Note: The Final Filter Grille should be opened (if it has
not been removed to ease removal of Front Cover.
H. Switch Control I Rear Cover
1. Remove 1 screw inside lower cord hook.
2. Release clips located on upper end of Rear Cover by
prying and lifting Rear Cover as illustrated.
3. Once Rear Cover is removed the ON/OFF button can
be released and the Switch Rod slid up and out of the
cleaner.
I. Intake Seal
1. The Intake Seal can be replaced by lifting out of
position. Upon reassembly insure that tab on back of
seal is positioned inside slot on Lower Handle.
o4/oo 149 E -6