Goldstar LXA1210ACL Owner's Manual page 14

Remove the backing from vertical and
horizontal insulation and attach them to
the inside of the wall sleeve as shown
below.
Remove the backing from the support
blocks and attach them to the inside of
the wall sleeve as shown below. Slide
the baffles in the slots of the support
b_ocks.
Wall
A+1/4"
(6 mm)
B+i/4"
(6 mm)
Insulation
Horizontal
Remove the backing from vertical
insulation and attach them to the back
of the unit as shown below.
Vertical
.................. Ins u latio n
6. Install the new unit into the wall sleeve.
7. Insert front insulation between the wall
sleeve and the unit. A flat-bladed
screwdriver or putty knife is
recommended.
Wall
Wail S,leeve
Fror
8. To assemble trim, insert the snaps into
the slots of others_
To install trim to the sleeve, slide the
trim through the unit until it is flush
with the wall sleeve
Wall
Trim (2 ea)