Table of Contents
Advertisement
Read these instructions completely and carefully.
If Range Has Electric Ignition
There are sepam/e
ignition
dexices ti)r tile left
and fight hand sudhce burners. Both of these
ignitors are ON when any knob is turned to the
UTE setting. The ignitors will spark as long as any
of the top burner knobs are at the LITE setting.
In the event of an electrical power taihne, the top
burners (an still be used. To light a burner, hold a
lighted kit(hen match a(!jacent to the top burner
to be used and mrn valve knob to LITE. U SE
EXTREME CAUTION.
Oven Pilot Adjustment
On pilot models remove thermostat knob.
Check position of pilot gas selector to make sure
selector is turned to the correct position fi)r the
ffpe of gas that is to be used. To change/o
LR
insert small blade screwdriver in slot and mrn
fiflly clockwise so that indicator poims to LR To
change to NAg mrn fiflly counterclockwise
so that
indicator points to/VAT.
• If desired, the gas to the oven pilot can be
turned offby turning the selector so the pointer
is at the OFFposition, nfidway between the LP
and NATsettings. (Thermostat
on your range
may not appear exactly as sh_wn in diagrmn.)
Ovenpilot selector key
switchesfrom LPto NAT
Pointer
Front view
• On electric ignition models the gas to tlle oven
burner can be turned oil A iilantlal shuFofl
valve is provided on manifold pipe.
St o
Oven Operation
[]
With tile oven dmrmostat trial in the OFF
position, light standing pilot on oven burner
pilot assembly. On electric ignition models
do not attempt to manually light the oven
pilot.
[]
Turn the thermostat trial to any temperature
setting. The oven pilot flame will enlmge
and engulf the mer{u U bulb. After
approximately
30-45 seconds the main
burner will come on.
With control knobin OFF
position,light standingpilot.
Flameshouldappearasshown.
[]
The oven can be used during
periods
of
power outage.
(See the Using the surface
units section.)
Mercury bulb
C
31
Advertisement
Table of Contents
