How To Attach; Beforeusing Tool; Cleaningcarpeted Stairs - Hoover SteamVac FH50046 Owner's Manual

HOW TO ATTACHTOOL
A CAUTION
To reduce the risk of injury from moving paris,
unplug cleaner.
AII tools connect to the hose in the same manner.
4.7 Attach tooI to connector end of hose by sliding it
onto connector until the tab (I) locks it securely.
Using your thumb, push forward and up on the latch
(J) to remove tool as shown,
BEFOREUSING TOOL
It may be necessary to remove air from the system
("pdme the pump _) so the clean solution wilf flow to
the to01, Follow these steps:
1. Attach tool to hose and turn the carpet cleaner ON.
2, Put the tool on a hard surface or against your
hand to brock off the suction.
3. Wait a few seconds (can take up to 15 seconds).
Then squeeze [he tdgger and begin cleaning.
CLEANINGCARPETED STAIRS
Place handle in upright position. Agitator brushes
will not rotate whi_e handle is in upright position.
Fill Clean Water Solution Tank with HOOVER ®
Detergent according to instructions on pages 8.
Attach tool to end of hose.
Hose length may require that machine be placed at
the top of the stairs to clean upper half of stairway
and at bottom of stairs to clean lower half.
To prevent machine from falling, use extra caution
when cleaning on stairs.
• IMPORTANT.
Do not place carpet cleaner on stairs.
DO not point tools toward people or pets.
Dry hands and plug carpet cleaner into a properly
grounded ouUet.
Turn carpet cleaner ON. If necessary, refer to
"Before Using Tool" Section to remove air from
system.
4.8 Pro-spray the carpeted stair by holding the tool
(A or B in Fig. 4.1) about one inch above the carpet
and push it forward while pressing the trigger
(equals one wet stroke).
!
!
4.g Position too] against the riser and slightly press
it into carpet pile. Press the .[rigger and pull the tool
sIowiy ever the carpet (second wet stroke). Release
trigger at end of stroke.
Lift tool, and position it against riser. Pull fool slowly
ever carpet without pressing trigger (dry stroke).
It is best to alternate wet and dry' strokes as
described above. End with more dry strokes to aid
in faster drying of carpet.
Overlap strokes by it2 inch to help prevent
streaking,
To avoid saturating carpet, do not use mere than 4
wet strokes over any one area. Always end with dry
strokes,
If additional cleaning is necessary, ,wait until the
carpet is completely dry before using the tool again.
t4