Advertisement
USING THE GENIUS REMOTE
TO CONTROL
VCR FUNCTIONS
Operating the pre-Coded function for your VCR
This Genius Remote is designed to operate different types of VCRs. You must first program the Genius Remote to match
the remote system in your VCR. (Refer to Table I on page 25).
I.
Set the MULTI-PAGE select switch to "VCR."
2.
Set the USE/LEARN mode select switch on the rear side of the Genius Remote to =USE."
3.
Turn ON yourVCR.
4.
Aim the Genius Remote control at the front of your VCR.
5.
While holding down the SELECT button, press the button that matches your VCR as shown on page 25. Continue
to hold down both buttons. The channels ofthe VCR will begin changing when the correct button is pressed. When
this occurs, the Genius Remote Control is programmed for your VCR. If the VCR channels do not change after 5
seconds, try a different Genius Remote button.
6.
Release both buttons when the VCR starts to change channels. The Genius Remote will now control your VCR.
NOTES:
1. IfyourVCR cannotbeoperatedafterperforming
the above procedures,this means that your
VCR's codes have not been preceded intothe
GENIUS REMOTE. Please store your VCR
codes in memory by using the USER mode
(Refer to page 26).
2. The GENIUS REMOTE CONTROL willremem-
berthe codesyou have programmedin untilthe
batteriesare removed from the GENIUS RE-
MOTE CONTROL. After replacingthe batteries
repeat theentireprogramming procedure stated
above.
3. If you have a play back only VCR (no CH UP/
DOWN function), pleasefollow operatingstep5
described aboveand thenchecka VCR function
until y oufindthe button that willallowthepreceded
VCR buttons to operateyourVCR.
@
®
PRECODED VCR BU'R'ONS
These buttons alwaystransmitthechosenpreceded
VCR codes.
SELECT BUTTON
Thisisfor settingupthe GeniusRemote totransmit
the VCR's remote codes.
EXCLUSIVE TV BUTTONS
These buttonsare for operatingthe "IV.
READY
LEARN
23
Advertisement
