Requirements And Instructions - Haier GDZ22-1 User Manual

Hide thumbs Also See for GDZ22-1:
Table of Contents

Advertisement

Available languages

Available languages

Requirements
and
_nstructions
The following
are
specific
requirements
for proper
and
safe
operation
of your
dryer.
Failure
to follow
these
instructions
can create
excessive
drying
times
and
fire hazards.
1. Do not use plastic flexible
duct to exhaust
the dryer.
Excessive lint can build up
inside exhaust system and create
a fire hazard
and restrict air flow. Restricted
air
flow will increase
dryer times. If your present system is made up of plastic duct or
metal foil duct, replace
it with a rigid
or flexible
metal duct, Ensure present duct
is free of any lint prior to installing
dryer duct.
2, if the dryer is not exhausted
out doors,
some fine lint will be expelled
into the laundry
area. An accumulation
of lint in any area of the home can
create a health and fire hazard,
To reduce risk of fire, dryer MUST BE
EXHAUSTED OUTDOORS.
3. Do not allow combustible
material
(for example:
clothing,
draperies/curtains,
paper)
to come in contact
with exhaust system. The dryer
must not be exhausted
into a chimney,
a wall, a ceiling,
or any concealed
space
of a building
which can accumulate
lint, resulting
in a fire hazard.
4, Exceeding
the length of duct pipe or number
of elbows allowed
in
the "Maximum
Length" charts can cause an accumulation
of lint in
the exhaust
system. Plugging
the system could create a fire hazard,
as well as increase
drying
times,
5, Do not screen the exhaust
ends of the vent system, nor use any screws
or rivets to assemble the exhaust
system, Lint can become
caught in the screen,
on the screws or rivets, clogging
the duct work and creating
a fire hazard
as well
as increasing
drying
times. Use an approved
vent hood to terminate
the duct out-
doors,
and seal alIgoints
with duct tape.
All male duct pipe fittings must be
installed
downstream
with the flow of air.
_
xplosion
hazard:
Do not install the dryer where
gasoline
or other flammables
are kept or stored.
If the dryer
is installed
in a garage,
it must be minimum
of 18 inches (45,7 cm)
above the floor,
Failure to do so can result in death, explosion,
fire or burns.
13

Advertisement

Chapters

Table of Contents
loading

Table of Contents