Exit Screen - Intel VS440FX Technical Specification

NOTE
If you set the Security hot key and the APM hot key (refer to Section 3.15.9.5) to the same key, the
APM function has priority.

3.15.14 Exit Screen

This section describes how to exit Setup with or without saving the changes you have made.
3.15.14.1 Exit Saving Changes
Exits Setup and saves the changes in CMOS RAM. You can also press the <F10> key anywhere
in the Setup utility to do this.
3.15.14.2 Exit Discarding Changes
Exits Setup program without saving any changes. This means that any changes you have made
while in Setup are discarded and not saved. Pressing the <Esc> key in any of the four main screens
will also exit and discard changes.
3.15.14.3 Load Setup Defaults
Returns all of the Setup options to their defaults. The default Setup values are loaded from the
ROM table. You can also press the <F5> key anywhere in Setup to load the defaults.
3.15.14.4 Discard Changes
Discards any changes made up to this point in Setup without exiting Setup. This selection loads
the CMOS RAM values that were present when the system was turned on. You can also press the
<F6> key anywhere in Setup to discard changes.
BIOS and Setup Utility
65