GE WSLS1100 Owner's Manual & Installation Instructions page 13

Installation Instructions
WASHER CONNECTIONS FOR PORTABLE MODEL
WSLP1100--ONE-FAUCET CONNECTIONS
Use the hose connector provided with the washer for a
one-t;i t/(et connection,
TO CONNECT THE WASHER:
[] REMOVE THE UNI-COUPLE ®
HOSE FROM INSIDE THE
WASHER BASKET
COLD Water
Suppl,/
Connection
Connector
Uni-Coupler H ose
[] CONNECT TO WATER LINE
Attach the hose connector to the faucet adapter by
pulling down on the locking collar while lifting up
on the connector tmtil it snaps into place. Make
sure the water filter provided is in place.
Locking C ollar
Hose Connector
[] CONNECT TO VALVE INLET
Attach the COLD water supply connector to the
COLD water valve inlet (color BI,UE). Make stlre
the washer is inside the c(mnector before
tightening.
I_ TIGHTEN CONNECTOR
Tighten the connector, ensm'ing the threads are
aligned properly for tightest fit. Inspect fin" kinks
or binding of the hose.
NOTE: Do not remove the plastic cap fl'om the HOT
water inlet fl)r tmi-coupler connections as leakage may
OCC/II:
[] CONNECT DRAIN HOSE
Attach the drain hose to the rear ot the washer.
Install the clamp on the drain hose and tighten
to I)rexent .... leakage, of water.
13