GE WSLS1100 Owner's Manual & Installation Instructions page 11

Installation Instructions
WASHER CONNECTIONS FOR STATIONARY MODEL
WSLS1100
^,*
WARNING:
Make sure the
washer is un )lugged
[] FLUSH WATER LINES
Run s()me water fl'om the hot and cold fimcets to flush
the water lines and remoxe particles that mioht_ cloo-
the water xdxe screens.
[] CONNECT TO WATER LINES
Connect tile inlet hose ends to tile HOT and COLD
water fimcets tightly by hand, then tighten another %
[tli'n with pliers. TtlFn the water on and check tot leaks.
[] CAREFULLY MOVE THE WASHER
TO ITS FINAL LOCATION
[] CONNECT DRAIN HOSE
Fom_ a U shape on tile end of tile drain hose with tile
hose pointed toward tile drain. Place tile hose in a
latmd_' mb or stand pipe and secure it with a cable tie
(not inchlded).
NOTE: If tile drain hose is placed in a stand pipe
without limning a U shape, a siphoning action could
occm'. There must be an air gap around tile drain
hose. A sntlg hose fit can also cause a siphoning action.
CableTie
Laundry Tub
Cable Tie
Cable Tie
Stand Pipe
[] PLUG THE POWER CORD INTO A
GROUNDED OUTLET
Insure proper groun/
exists before use
//