GE JGBP35WEV3WW Use And Care & Installation Manual page 43

[] IHSTALL|NG THE AHTI-TiP DEVICE
WARNING:
• Range MUST be secured with an
approved Anti-Tip device.
. Unless properly installed, the range could
be tipped by you or a child standing, sitting
or leaning on an open door:
° After installing the Anti-Tip device, verify
that it is in place by carefully attempting to
tilt the range forward.
• This range has been designed to meet all
recognized industry tip standards for all
normal conditions.
° The use of this device does not preclude
tipping of the range when not properly
installed°
• If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB02X7909.
1. Mark the wall where the RIGHT EDGE of the
range is to be located. Be sure to allow for the
countertop overhang if you intend to install the
range next to cabinets.
_ Anti-_p I
Slotted -I_::_" _!_'-------_
I
head
_l_a,,--, !ill
screw_ € ffllwa,plateI
Approx, 20 °" / ]
_'_311Ztt // Marked edge
/
_ 78 // of range
ji/J"_,,,,_
2. Locate the outside edge of the device 2¼"
toward the center of the range from the marked
edge of the range.
3. Using the device as a template, mark the
position of the hole for the screw.
4. For wood construction, drill a pilot hole at an
angle of 20 degrees from the horizontal° A nail
or awl may be used if a drill is not available.
Mount the Anti-Tip device with the screw
provided.
i i iimH IIHII'HINIIHH, I
For cement or concrete construction, you
wilt need a 1/4" x 1½" lag bolt and a 1/2" O.D.
sleeve anchor, which are not provided. Drill
the recommended size hole for the hardware.
Install the sleeve anchor into the drilted hole
and then install the lag bolt through the device.
The bolts must be properly tightened as
recommended for the hardware.
Wallboard Back of
range
Anti-t_p
device
Wood screw
5. SIide the range against the wall, and check
for proper installation by grasping the front edge
of the cooktop and carefiflly attempting to tilt the
range forward.
ii H H ,,Hllll HHI'
WREHALL HOOKUPS ARECOMPLETED:
MAKESUREALL CONTROLSARE LEFTIH THE
OFFPOSITION.
MAKESURETHE FLOW OF COMBUSTIONAHD
VEHTILATIONAIR TO THE RANGEIS
UHOBSTRUCTED.
COHVERTIHG TO LP GAS
(or converting back to natural gas from LP)
This range leaves the factory set for use with
natural gas. If you want to convert to LP gas, the
conversion must be performed by a qualified LP
gas installer.
The conversion inslxuctions, sticker and LP
orifices can be found attached to the range next
to the pressure regulator.
There is a second set of instructions included in
the envelope containing the product wiring
diagrams on the back of the range. Keep these
instructions and the orifices in case you want to
convert back to natural gas.
43