GE JGBP35WEV3WW Use And Care & Installation Manual page 26

OPERATING THE SELF-CLEANING OVEN
(continued)
How to Delay Start of Cleaning
Delay Start is setting the oven timer to start the clean
cycle automatically at a later time than the present
time of day.
NOTE: Before beginning make s_e the oven clock
shows the correct time of day°
Quick Reminder--Delay Start for Serf-Clean:
1. Prepare the oven for cleaning.
2. Close the oven doo_
3. Press the AUTO CLEAN or AUTO SELF
CLEAN pad.
4, Press the + or - pad until the desired Clean
Time appears.
5. Press the STOP TIME pad.
6. Press the + or - pad until the desired Stop
Time appears in the display°
For example: Let's say it's 7:00 and you want the
oven to begin self-cleaning at 10:00 after you're
finished in the kitchen.
1. Prepare the oven for cleaning.
2. Close the oven door and sli_
the latch handle to the right
as far as it will go. Make
sure the oven light is off
Never force the door latch handle. Forcing the
handle may damage the door lock mechanism.
3. Press the AUTO CLEAN or AUTO
AUTO SELF CLEAN pad.
CLEAN
4. Press the + or - pad,, The oven is set_
5. The Clean Time is preset for 3 hours° You can change
the Clean Tune to any time between 2 and 4 hours,
depending on the amount of soil in your oven. If a
shorter Clean Time is desired, press the - pad until
the desired Clean Tune is displayed.
f _ 6. Press the STOP TIME pad. "I0:00"
/ STOP ] anDears in the display and "STOP
q_/IE" flashes.
The control automatically sets the
Stop Time by adding the Clean Time
to the time of day..
In this example, the time of day is 7:00
and the Clean Time is 3 hours° Adding 3
hours to the time of day equals 10:00o
7. Change the Stop Time from 10:00 to 1:00 by
pressing the + pad until "1:00" appears in the
display. The words "DELAY CLEAN" will also
appear in the display.
The self-clean cycle will automatically begin at 10:00
and finish at 1:00_ The word "ON" will appear in the
display at 10:00o
When the oven locks, the word "LOCK" will be
displayed and a short time later the door latch handle
will be locked in position. It will not be possible to
open the oven door until the temperature drops below
the lock temperature.
When the clean cycle is finished, the word "CLEAN"
wqjl go out in the display and the oven will begin to
cool. When the oven temperature has fallen below the
locking tempemtalre the word "LOCK" goes out and
the door can be opened.
8. When the LOCK light is off, slide the latch handle
to the left as far as it will go and open the door,
Never force the latch handle. Wait until the
word "LOCK" goes out in the display. Forcing
the latch handle may damage the lock.
26