Care And Cleaning - GE JGBP35WEV3WW Use And Care & Installation Manual

Xl44 self-cleaning gas range
Table of Contents

Advertisement

CARE AND CLEANING
Proper care and cleaning
are important
so your range %5_ give you efficient
and satisfactory
service° Follow these directions carefully in caring for it to
help assure safe and proper maintenance°
BE SURE ELECTRICAL
POWER
IS DISCONNECTED
BEFORE
CLEANING
ANY PART OF YOUR
RANGE.
I CAUTION:
DO NOT OPERATE
THE BURNER
WITHOUT
ALL BURNER
PARTS AND DRIP PANS
(IF SO EQUIPPED)
IN PLACE.
Sealed
Burner Assemblies
(on some models)
Burner
Heads (on
sealed burners
only)
Grate
Burner cap
Drip pan
(on some models)
Burner head
Electrode
Turn all controls
OFF before removing
the
burner parts and drip pans (if so equipped).
The burner
grates, caps, burner heads and drip
pans (if so equipped)
can be lifted off, making them
easy to clean.
The electrode of'
the spark igniter is
exposed
when the
burner head is
removed.
When one
burner is turned to LITE, all the burners spark.
Do not attempt to disassemble
or clean around
any burner while another burner is on. An electric
shock may result, which could cause you to knock
over hot cookware.
For proper
ignition, make sure the small hole in
the section
that fits over the electrode
is kept open. A
sewing needle or wire twist-tie
works well to unclog it.
The slits in the burner heads of your range must be
kept clean at all times for an even, unhampered
flame.
You should clean the surface burners routinely,
especially
after bad spi_overs,
which could clog
these openings.
To remove
burned-on
food, soak the burner heads
in a solution
of mild liquid detergent
and hot water
for 20-30 minutes. For more stubborn stains, use a
toothbrush.
Before
putting the burner head back, shake out
excess
water and then dry it thoroughly
by setting
it in a warm oven for 30 minutes.
Replace
the burner caps. Make sure that caps are
replaced
on the correct size burner. There is one
small, 2 medium
and one large cap.
Burner Caps (on
sealed burners
only)
Lift off when cool. Wash bumer
caps in hot, soapy water and rinse
with clean water. You may scour
with a plastic scouring pad to
remove burned-on
food particles_
Dry them in a warm oven or with a
cloth--don't
reassemble
them wet.
Replace the bmner caps°
28
Make sure that caps are replaced
on the correct size burner. There
is one small, 2 medium
and one
large cap.
small
medium _Q
large
medium
medium
-@
-@ Q
L.a¸
_
_
_
Front of Range
--
small
large

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents