Selecting A Patch - Zoom B2.1u Operation Manual

To try out the various effects of the B2.1u, we recommend that you simply play your instrument while
switching patches.
Turn power on
Use a shielded cable with mono phone plug
to connect the bass guitar to the [INPUT]
jack of the B2.1u.
When using the B2.1u with the AC
adapter, plug the adapter into the outlet
and plug the cable from the adapter into
the [DC IN] jack on the B2.1u.
Set the [POWER] switch on the rear
panel of the B2.1u to ON.
Turn the bass guitar amplifier on and
adjust the volume to a suitable position.
Set the B2.1u to play mode
If the Module selector is set to a position
other than "PLAY", set it to "PLAY".
The bank and patch
that were selected
when the power was
last turned off will
appear on the display.
HINT
Immediately after turning the B2.1u on,
the unit will be in play mode, even if the
Module selector is set to a position other
than "PLAY".
Select a patch
To switch the patch, press one of the [W]/[Q] foot switches.
Pressing the [W] foot switch calls up the next lower patch, and pressing the [Q] foot
switch calls up the next higher patch.
Repeatedly pressing one foot switch cycles through patches in the order A0 – A9 ... d0 – d9
→ 00 – 09 ... 30 – 39 → A0, or the reverse order.
8

Selecting a Patch

A 1
Bank name Patch number
ZOOM B2.1u