Control - Zoom B2.1u Operation Manual

Effect Types and Parameters

CONTROL

CONTROL module
Serves for making pedal settings and lets you control the foot switch function and master
level setting applying to all patches.
RTM DESTINATION
See Table 6
Selects the modulation target module
that is controlled with the built-in
expression pedal (see Table 6).
RTM (Real Time Modulation): The effect parameter can be changed with the expression pedal in real time.
Table 6
Setting
OFF
oF
Volume
VL
WU, Wd, WH, WL WAH/EFX module (*)
ZNR/MIX module (*)
bU, bd, bH, bL
MU, Md, MH, ML MOD/SFX module (*)
DELAY module (*)
dU, dd, dH, dL
REVERB module (*)
rU, rd, rH, rL
The operation of modules denoted by (*) changes as
follows, according to the letter at right.
U
UP
The parameter is at minimum when the pedal is fully raised and
at maximum when the pedal is fully pushed down.
D
DOWN
The parameter is at maximum when the pedal is fully raised and
at minimum when the pedal is fully pushed down.
H
HIGH
When the pedal is fully raised, the parameter is at the value set in
the patch. When the pedal is fully pushed down, the parameter is
at maximum.
L
LOW
When the pedal is fully raised, the parameter is at minimum.
When the pedal is fully pushed down, the parameter is at the
value set in the patch.
HINT
When the ZNR/MIX module is selected as modulation target, the pedal
adjusts the mixing balance of the DRIVE/SYNTH module (→ p. 30).
34
FS
When a foot switch (FS01) is connected
to the [CONTROL IN] jack, this selects
the function that can be operated with
the foot switch (See Table 7). The
function selected here applies to all
patches.
Modulation target
See Table 7
Adjusts the master level for all patches.
Table 7
Setting Function
Bypass/Mute
bP
Tap tempo
tP
Bank up
bU
Rhythm function on/off
rH
Delay hold
dH
Delay mute
dM
"UP"
Maximum value
Minimum value
"DOWN"
Maximum value
Minimum value
"HIGH"
Maximum value
Value set in patch
"LOW"
Value set in patch
Minimum value
MASTER LEVEL
0 – 98, 1.0
ZOOM B2.1u