Storing And Swapping Patches - Zoom 707II Guitar Operation Manual

Storing and Swapping Patches

This section describes how to store an edited patch in memory, and how to swap patches in
the USER group.
1.
In play mode or edit mode, press the
[STORE/EXECUTE] key.
The 707II enters the store standby condition.
The patch name and the indications "SAVE"
and "SWAP" are shown alternately on the
display. The [BANK/PATCH] indicator shows
the bank and patch number.
S T O R E ?
H
INT
To change the name of an edited patch, see p. 38.
2.
Use the MODULE [
select either "SAVE" or "SWAP".
N
OTE
If the original patch is from the PRESET group,
"SWAP" cannot be selected.
3.
Use the TYPE [
W Q
[ ]/[ ] foot switches to select the
target patch for storing.
The name of the newly selected patch and the
indication "STORE?" are shown alternately on
the display. The bank and patch number flash on
the [BANK/PATCH] indicator.
N
OTE
The PRESET group cannot be selected as store
target. If you press the [STORE/EXECUTE] key
while a patch from the PRESET group is selected,
the selection automatically changes to "A0" in the
USER group.
20
ZOOM 707II GUITAR
E 3
E R
]/[ ] keys to
W Q
]/[ ] keys or the
4.
To carry out the store or swap
operation, press
EXECUTE] key once more.
The store or swap operation is performed, and
then the unit returns to the original mode. If the
patch in step 1 was being edited, the editing
changes are stored.
If you press the [CANCEL/EXIT] key instead
of the [STORE/EXECUTE] key, the store/swap
operation is canceled and the unit returns to the
original mode.
the [STORE/