Using The Tuner Function - Zoom 707II Guitar Operation Manual

Using the Tuner Function

The 707II incorporates an auto-chromatic tuner for guitar. To use the tuner function, the built-
in effects must be bypassed (temporarily turned off) or muted (direct sound and effect sound
turned off).
1.
To set the 707II to the bypass (mute)
condition, press and release both
W Q
[ ]/[ ] foot switches in play mode.
When you press and immediately release both
foot switches, the 707II goes into bypass mode.
B Y P A S S
While the 707II is in the bypass condition, all
effects are off and only the direct sound is
output. The expression pedal works as a volume
pedal.
When you press and hold both foot switches for
at least 1 second and then release them, the
707II goes into mute mode.
Press and release
after at least 1 second
M U T E
While the 707II is in the mute condition, there is
no sound output from the [OUTPUT/PHONES]
jack.
2.
Play the open string you want to tune.
The [BANK/PATCH] indicator shows the note
which is closest to the current pitch. Tune your
instrument until the note indication shows the
desired note.
Release immediately
* *
* *
The note is shown on the left part of
the indicator
A
A
B
C
C
A 8
Pitch is sharp Correct pitch Pitch is flat
The more the pitch is off,
the faster the indicator rotates
To the right of the note, a symbol indicates
by how much the tuning is off.
3.
To change the reference pitch of the
tuner, use the TYPE [
The current reference pitch is briefly shown on
the display. The default setting after power-on is
center A = 440 Hz.
4 4 0 H Z
Reference pitch value
4.
While the reference pitch is shown,
you can change the pitch by pressing
W Q
the TYPE [ ]/[ ] keys.
The available setting range is 435 – 445 Hz in
1-Hz steps. When the 707II is turned off and on
again, it will be reset to 440 Hz.
W
5.
Press one of the [
The 707II returns to the play mode.
ZOOM 707II GUITAR
D G
D G
E
F
F
W Q
]/[ ] keys.
Q
]/[ ] foot switches.
11