Pedal Wah/Pedal Pitch Key - Zoom GFX-4 Operation Manual

Parameter value
Maximum
UP
dn
Minimum
When the effect type of the MODULATION
module is PDLPIT (pedal pitch) or PDLWAH
(pedal wah), the "Hi" setting has the same effect
as "UP" and "Lo" has the same effect as "dn".
• Parameter Knob 3
• • • •
Determines whether to control the DELAY/REVERB
module with the expression pedal in real time. You can
select "oF" (off), "UP", "dn" (down), "Hi" (high), or
"Lo" (low).
When a setting other than "oF" is selected, operation is
the same as for EP-MOD.
6.
Make sure that modules selected in step 5 are
set to on. If required, switch the effect type used
in the module.
The parameter controlled by RTM depends on which
effect type is currently selected for the module. For
details, see the section "Effect Types and Parameters".

PEDAL WAH/PEDAL PITCH Key

Among the effect types that can be controlled by RTM, the two effect types PDLWAH (pedal wah) and PDLPIT (pedal
pitch) in the MODULATION module have a special key.
1.
In manual mode or program mode, press the
PEDAL WAH/PEDAL PITCH keys.
WAH/PEDAL PITCH
The PEDAL
for quickly adjusting pedal wah or pedal pitch. With each
push of the key, the edit display for "PDLWAH" and
"PDLPIT" is displayed alternately.
Lit when type has changed
2.
To use the pedal wah effect, select the
"PDLWAH" display. To use the pedal pitch
effect, select the "PDLPIT" display.
When one of these is selected, the patch setting
automatically becomes as follows.
20
ZOOM GFX-4
Hi
Value
programmed
in patch
Lo
EP-D/R
key are shortcut keys
7.
If required, store the patch, and return to
program mode.
When you now operate the expression pedal, the
respective parameter in the modules selected for RTM
will change.
Move pedal
When you push the expression pedal fully down, the
assignable switch performs the selected function
(switching between program mode and manual mode or
toggling the module on/off status).
Press down
For example, you may select the DRIVE and
MODULATION modules for RTM control and
store the patch with one module set to on and the
other set to off. If you then select the module
on/off function for the assignable switch, the
module controlled by RTM is switched every time
you push the expression pedal fully down.
• MODULATION module = ON
• MODULATION module effect type
= PDLWAH or PDLPIT
• UP if RTMSET display EP-MOD parameter = oF
3.
If required, use the parameter knobs on FX
panel 2 to set the effect parameter.
The effect parameter setting procedure is the same as for
regular editing. (For information on effect parameters, see
page 21.)
4.
If required, store the patch, and then return to
program mode.
When you now operate the expression pedal, the pedal
wah or pedal pitch effect is applied.