Attaching The Lift Handle
Lift Handle
Hex Screws
1. Attach the lift handle to the lift bracket on the right side of the auger housing assembly with two hex screws and
two flange lock nuts as illustrated in Figure 6.
2. Fasten the lift cable to the lift handle with two of the cable ties provided.Pull the cable ties until they're snug and
trim off any excess.
Mounting the Auger Housing Assembly
Support Tube
Front Pivot
Support Bracket
Cable Ties
Lift Bracket
Shoulder Bolt
Lift Assembly
Figure 6
Release Support Pin
Hooks
Figure 7
8
Flange Lock Nuts
Into This Hole
Support Pins