SECTION 5: CONTENTS OF CARTON
Before beginning installation, remove all parts from the carton to make sure everything is present. Carton contents
are listed below and shown in Figure 3. Part numbers are shown in parentheses.
•
One Auger Housing Assembly w/ Lift Linkage
•
One Undercarriage Assembly (packaged
separately w/ Upper V-belt 754-0371A)
•
One Chute Directional Support w/ Tilt Lever
•
One Lift Handle Assembly
•
One Upper Chute Crank Rod
Undercarriage Ass'y w/ Upper V-belt
(754-0371A) for electric PTO tractors
Lower V-belt
Lift Handle
Assembly
(Cable end
attached to
lift index rod
on auger
housing ass'y)
Self-adhesive
Reflectors
NOTE: Two upper drive belts are included with your snow thrower attachment. The belt (754-0371A) packaged with the under-
carriage assembly in the separate box is for use on tractor's equipped with an electric PTO. The other upper drive belt
(754-0481) is for use on tractor's with a manual PTO. Belt part numbers are stamped on the outer edge of the belts.
Upper V-belt (754-0481)
for manual PTO tractors
Cable Ties
Figure 3
5
•
Two Self-adhesive Reflectors (730-3000)
•
Four Cable Ties (725-0157)
•
Two Spare Shear Bolts (710-0890A)
& Hex Lock Nuts (712-0429)
•
One Upper V-belt (754-0481)
•
One Lower V-belt (754-0125A)
Upper Chute Crank Rod
Chute Directional
Support w/ Tilt Lever
Auger Housing Assembly
with Lift Linkage
Spare Shear Bolts
& Hex Lock Nuts
{