Panasonic DP-8025 Operating Instructions Manual page 193

Fax Parameter Table
* = Factory default setting
No. Parameter
097 Special Tray
No.1 - 3
099 Memory Size
(Flash Memory)
118 FAX Function Detect
131 Job Tracking
132 Via Fax Server
Fax Server Mail Address
140 LAN RLY XMT Request
141 LAN XMT Reduce
142 Relay XMT
143 Relay XMT Report
Continued on the next page...
Customizing Your Machine
Setting
*None Select up to 3 Special Trays that will not be used for printing received
faxes. One Tray must always be available for receiving Faxes.
Tray 1
(You can specify one Tray (1 ~ 3) for each selection No. 1, No. 2, and/or
No 3.)
Tray 2
Tray 3
- Displays the amount of base, and optional memory installed.
(Base Memory + Optional Memory)
Invalid Setting the number of digits for detecting a Fax Telephone number.
Upon detecting the specified number of digits, the machine will
4-Digits
automatically switch to the FAX Mode when it is in the Copier Mode.
5-Digits
*6-Digits
7-Digits
8-Digits
*None Selecting Job Tracking function.
None : Does not function.
Tx
TX : Valid only in sending.
Rx : Valid only in receiving.
Rx
Tx&Rx : Valid both in sending, and receiving.
Note: • Before performing this setup, you first need to set the FAX
Tx&Rx
FORWORD (Fax Parameter No. 054) parameter to Invalid.
•
Copy, Fax, Scanner, or Printer in the User Authentication
(General setting - Key Operater Mode No. 050)need to set
"Valid".
*Invalid Enter the Email address of the RightFax server when you enable the
RightFax function for the first time.
Valid
Note: • Before performing this setup, you first need to set the User
Parameter setting (General setting - Key Operater Mode
No. 000) in the Genral settings (For Key Operator) and, FAX/
EMAIL Settings (For Key Operator).
*Invalid Selecting whether the machine performs LAN Relay XMT Request.
Valid
*Invalid Selecting whether to automatically reduce from LEDGER / B4 to A4,
when LEDGER / B4 documents are transmitted via LAN.
Valid
Invalid :No reduction
Valid :Automatic reduction from LEDGER / B4 to A4
Invalid Selecting whether the machine accepts, and performs G3 relayed
transmission. (Relay Station Functions)
*Valid
Off Setting how the COMM. Journal for relayed transmission is sent to the
originator.
*Always
Off : Don't send.
Always : Always send.
Inc. only
Inc. only : Send only if communication has failed.
Comments
193