Installation - Alpine CDM-9825RB Owner's Manual

Installation

Caution (CDM-9825RB only)
Do not block the unit's fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit
and may cause a fire.
Air ventilation
hole
1
Bracket
Dashboard
Mounting sleeve
(Included)
No Pressure Here
No Pressure Here
Remove the Detachable Front Panel (refer to
page 4). Slide mounting sleeve from main unit
(see Removal Procedure below). Slide the
mounting sleeve into the dashboard.
2
Metal Mounting Strap
∗
Hex Nut (M5)
When your vehicle has the Bracket, mount the
long hex bolt onto the rear panel of this unit and
put the Rubber Cap on the hex bolt. If your
vehicle does not have the Mounting Support,
reinforce the head unit with the metal mounting
strap (not supplied). Connect all the leads of this
unit according to details described in the
CONNECTIONS section.
NOTE
For the screw ∗, provide a proper screw to the chassis
installing location.
<Rear side>
Rubber Cap
(Included)
Hex Bolt
(Included)
This unit
Screw
Bolt Stud
This unit
3
Slide the unit into the dashboard. When the unit is
in place, make sure the locking pins are fully
seated in the down position. This can be done by
pressing firmly in on the unit while pushing the
locking pin down with a small screwdriver. This
ensures that the unit is properly locked and will
not accidentally come out from the dashboard.
Install the Detachable Front Panel.
Lock pin
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to
push the locking pins to the "up" position (see
Fig. 3). As each pin is unlocked, gently pull out
on the unit to make sure it does not re-lock
before unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Front frame
This unit
Screws (M5 × 8)
(Included)
Mounting Bracket
21
-EN