GE PGSS5PJZASS Owner's Manual And Installation Instructions page 26

Installation Instructions
REPLACING THE FREEZER DRAWERS
(cont.)
o wo people may be required to complete
this procedure.
BOTTOM DRAWER
[] REPLACE THE BASE GRILLE
(if removed earlier)
A CAUTION: Be careful not t o
overtighten the screws since this mag crack
the grille.
Align the base grille and replace the 2 Phillips-
head screws on either side of the base grille.
[] ATTACH AND SECURE THE DRAWER
FRONT TO THE SLIDES
r_ Pull out the rail assemblies to the full length on
each side of the cabinet.
V
ATTACH AND SECURE THE DRAWER
FRONT TO THE SLIDES (CONT.)
There is a tab on each drawer rail and a slot
on each rail assemblg on the refrigerator. Align
the drawer rails with the rail assemblies, tilt
the drawer toward the refrigerator, and seat
the tabs into the slots of the rail assemblg.
Lower the drawer into position.
Slot Tab
E] Replace the screws to secure the drawer.
Rail
assembly---.-_.
Screw
26
@
%
B]
[]
B-1
REPLACE THE FREEZER BASKET
Place the rear of the basket onto the metal
slide brackets. There will be 2 pins on each
underside of the back that will align for
securing the basket.
Seat the front basket onto the metal slide
brackets and over the swing locks.
Turn the swing locks from vertical to horizontal
position to lock the basket in place.
Turn the divider slightlg to one side so the tabs
on the front fit into the vent slots on the basket.
Position the divider so the back locating tabs snap
into place in the back vent slots.
J' i '