Installing/Storing/Removing The Metal Handle; Installing Handle; Lowering Handle For Storage; Removing Handle - Craftsman 113.177895 Owner's Manual

Assembly (continued)
Installing/Storing/Removing the
Metal Handle
Your metal handle comes packaged in
the dust drum. You must remove the
metal handle from the dust drum and
install the handle in the correct direction,
bent area facing away from the back of
the Vac before continuing. (Also remove
the 8" wheel and set aside for
installation).
Latch (2)
Pull Down and
Slide Dust Drum
Out of Wet/Dry
Vac Unit
Installing Handle
Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
NOTE: An audible snap of release
buttons indicates successful engagement
of handle.
Press and
Hold Release
Buttons
Button (2)
Lowering Handle for Storage
To store Wet/Dry Vac, press and hold
release buttons while firmly sliding handle
down.
Removing Handle
Press and hold release buttons, as
shown. While firmly pushing in release
buttons, pull handle upwards to remove.
_ Handle
Handle
Downward