Insert Hose; Removing Vac From Storage Rack - Craftsman CMXEVBE179250 Instruction Manual

6. Snap the Power Cord into the Cord Retainers in the
front surface of the Rack and loop around the Cord
Keeper behind the Wand Storage Area.
The Cord may exit on either the left or right side.
Plug the Power Cord into the electrical outlet. Do not
fasten Power Cord to wall in any way.
Fig. P
Electrical
Outlet
Insert Hose (Fig. Q)
Insert the Hose Locking End of the Hose into the Vac Inlet
Port. The Hose should snap into place.
To Remove the Hose from the Vac, press the Release
Button in the Hose Assembly and pull the Hose out of the
Vac Inlet Port, as shown.
Fig. Q
Hose Release Button
Hose Assembly
10
SP7085-2 CMXEVBE179250.indb 10
Removing Vac from Storage Rack (Fig. R)
!
1. With your right hand, raise the Carry Handle.
Cord
Keeper
2. With your left hand, depress the Release Tab located
Cord
3. Lift up on the Carry Handle, and pull the Vac up and
Fig. R
Vac Inlet
Port
WARNING:
Unplug Vac and remove power cord from rack before
removing Vac.
on the upper left corner of the Storage Rack.
out of the Storage Rack.
Storage Rack
Release Tab
Carry Handle
Vac
PULL UP
AND OUT
10/24/19 12:48 PM