Installation; Caster/Caster Foot Assembly; Hose Clip Assembly; Carry Handle Assembly - Craftsman CMXEVBE175840 Instruction Manual

INSTALLATION

Caster/Caster Foot Assembly (Fig. C)
1. Remove the Powerhead Assembly from the Dust Drum
and set aside.
2. Turn the Dust Drum upside down on the floor.
3. Insert the Caster Feet into the bottom of Drum, as
shown (4 places).
4. Push on the Caster Foot until the Foot is flush with
bottom of the Dust Drum.
5. Insert the Caster Stem into the Socket of the Caster
Foot, as shown (4 places).
6. Push on the Caster until the Ball on the Caster Stem
is inserted all the way into the Socket. You will hear
the Ball snap into the Socket and the Caster will swivel
easily when positioning is correct.
7. Turn the Drum upright.
Fig. C
Dust
Drum
6
SP7075-1 6, 9, 12, 16, 20 Gallon 2019.indb 6
Fig. D
Screw
Hose
Clip
Powerhead
Assembly
Caster
Carry Handle Assembly (Fig. E)
Caster Stem
1. Place the Carry Handle on the Wet/Dry Vac Powerhead
Assembly.
Caster Ball
2. Tighten both Screws to assemble the Carry Handle on
the Powerhead Assembly.
Caster
Foot
Fig. E
Pin
Hole
20 Gallon (75 Liters) Shown
2/22/19 10:31 AM