Assembly; Parts Packed Separately In Carton; To Remove Edger/Trimmer From Carton - Craftsman 536.772300 Operating Instructions Manual

Parts packed separately in carton (not shown full size)
1 - Owner's Manual (not shown) 1 - Container SAE30 oil
(1) - Hair Pin
,/_ CAUTION: Always wear safety
glasses or eye shields while assembling
Edger/Trimmer.
The figure to the right shows the Edger/
Trimmer completely assembled.
References to the right or left hand side
of the Edger/Trimmer are from the viewpoint
of the operator's position behind the unit.
TO REMOVE EDGER/TRIMMER
FROM CARTON
• Remove the bottle of oil and parts bag
from the carton.
• Cut down all four corners of the carton.
• Remove packing material on Edger/
Trimmer.
• Loosen T-knobs and raise handle to
operator's position allowing control rod to
swing freely.
• Tighten T-knobs. T-knobs should be to
the outside of the handles as shown in
figure below.
T-Knob '!_=
• Insert end of control rod left to right
through the hole in the quill support arm.
Attach with hair pin found in parts bag.
See figure below.
• '_'" Hair Pin Control Rod