Installation Instructions - GE PTC22MFMALCC Owner's Manual And Installation

Profile customstyle refrigerators 22 models
Table of Contents

Advertisement

Installation
Instructions
Refrigerat0
Profile Model 22
I Questions?Carl 800.GE.CARES (800.432.2737)or Visit
our Website at:
www.GEAppliances.com
In Canada, call 1.800.361.3400 o r VisitourWebsite a t: www.geappliances.ca
I
BEFORE YOU BEGIN
Read these
instructions
completely
and carefully.
• IMPORTANT
- Save t hese
instructions
for local inspector's
use.
• IMPORTANT
- Observe all
governing
codes and ordinances.
• Note
to Installer
_ Be sure
to
leave these
instructions
with the Consumer.
• Note
to Consumer
_ Keep
these instructions
fbr future reference.
• Skill level - Installation
of this appliance
requires
basic
mechanical
skills.
• Completion
time -
Refrigerator
Installation
15 minutes
• Proper installation
is the responsibility
of the
installer.
• Product failure due to improper
installation
is not
covered
under the Warranty.
WATER
SUPPLY
TO THE ICEMAKER
(ON SOME MODELS)
If the refi'igeramr
has an icemakm,
it will have to be
connected
to a cold water line. AGE water supply kit
(containing
robing, shutoff valve, fittings and
instructions)
is available at extra cost fi'om your dealm;
by"visiting our Website at www.GEApplimaees.com
(in
Canada at www.geapplimaees.ca)
or fi'om Parts and
Accessories,
800.626.2002
(in Canada 1.888.261.3055).
REFRIGERATOR
LOCATION
• Do not install the refi'igerator where the tcmperamre
will go below 60°F (16°C) because it will not rtm often
enough
to maintain proper mmperatures.
• Do not install the refrigerator
where the mmperamre
will go above 100°F (37°C) because it will not perfbrm
properly:
• Install the refligerator
on a floor strong enough
to
support it when fiflly loaded.
CLEARANCES
Allow the fbllowing clearances for ease of installation,
proper air circulation
and plumbing
and electrical
connections:
• Sides 1/8"
(3 mm)
• Top 1" (25 mm)
• Back 1/2" (13 mm)
If the refl'igerator
is against
a w-all on either side, allow a
1/8" (3 mm)
door clearance.
When using the trim kit:
If the cabinet
is not flush with the enclosure
or is
recessed,
allow an additional
clearance
of 1/2" (13 mm)
on the door hinge side and at the top. Ensure
proper
door opening:
Preferred
Topof Cabinet
Flush
Flush ._,_
with
Cabinet
_I
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents