Top Plate( - Omnimount Lift 42 Instruction Manual

Attach the Screen Support(4) and Top Plate(5) to the Lift
Column(2):
• Before attaching the top plate ensure that the rubber guide on the "pigtail" is
secured in the square cutout on what will be the front of the lift column (fig. A).
Failure to do so may result in damage to the wire.
• Once the pigtail is secure, line up the holes on top of the screen support with the
holes in the lift column. Make sure the plate is on the same side as the pigtail,
the pigtail will be protected by the screen support (fig. B). Finally line up the
holes on the top plate with the holes on the screen support and secure the
assembly with four 6mm x 30mm screws (P). Note that top plate is also counter
sunk for flush mounting (fig. C).
Before
Figure B
4
2
Step 6
After
Figure A
5
Figure C
x4
5
4
13