Craftsman 113.247440 Owner's Manual page 32

trouble shooting eBectronics
PROBLEM
qo display when
is pressed.
Display shows
[ ..... ]
PROBABLE CAUSE
Display dark.
Display blanks after
a few minutes.
Display shows
I '- '-= '- '-1
CL-CL-
1 Battery incorrectly
installed or missing
2 Battery contacts dirty
or corroded
3 Battery dead
4 Digital display failure
Normal display when
battery is first installed in
unit
2 Bevel display was not
ref-set
3 Poor battery contact to
indicator display leads
causing intermittent
power to display
4 Digital display failure
Display dim, 1 Low battery voltage
2. Temperature below 32 ° F.
1. Temperature above 120 ° F.
! Normal
Display will reset to
zero but immediately
shows when bevel is
moved.
I _-rrEt
Display does not
change when bevel
is moved,
Head tilted too rapidly
for digital display to
monitor
1 Encoder or digital
display defective
t Wrong display function
selected
2. Encoder or digital
display defective
3 Rib on lower slide
not engaging encoder.
SUGGESTED CORRECTIVE ACTION
- Adjust battery position in compartment
- Install battery
- Clean battery contacts
- Replace battery Battery is 6 volt, size J,
alkaline type
- Have electronics checked by qualified
technician. Repair service available at nearest
Sears Store.
- No action required
-- Follow procedure for setting bevel reference
point in this manual
- Clean battery contacts Adjust battery position
in compartment
- Have electronics checked by qualified service
technician. Repair service available at nearest
Sears store.
Replace battery Battery is 6 volt, size J,
alkaline type
Allow saw to warm above 32°F.
- Allow saw to cool below 120 ° F.
- Press _ key Display should return
- Reset bevel zero reference
Have electronics checked by qualified
technician. Repair service available at nearest
Sears store,
- Select bevel function
- Have electronics checked by qualified
technician, Repair service available at nearest
Sears store.
- Have electronics checked by qualified
technician. Repair service available at nearest
Sears store.
32