Troubleshooting - Craftsman 536.797470 Owner's Manual

• To remove gasoline, run the engine
until the tank is empty and the engine
stops.
o if you do not want to remove gasoline
a fuel stabilizer (such as Sears
Craftsman fuel stabilizer No. 33500)
may be added to any gasoline _left in
the tank to minimize gum deposits
and acids+ if the tank is almost empty,
mix stabilizer with fresh gasoline in a
separate container and add some to the
tank. Always follow instructions on
stabilizer container. Then run engine at
least 10 minutes after stabilizer is added
to allow mixture to reach carburetor.
Store Edger/Trimmer in a safe place. See
IMPORTANT under STORAGE (EN-
GINE).
Store the EdgerTrimmer in the wheels-
down, operating position,+ If the Edged
Trimmer is stored in any other position, oi!
from the crankcase could enter the
cylinder, causing a service problem,,
You can keep your engine in good operating
condition during storage by:
• Changing oil.
• Lubricating the piston/cylinder area
This can be done by first removing the
spark plug and squirting dean engine
oil into the spark plug hole, Then cover
the spark plug hole with a rag to absorb
oil spray, Next, rotate the engine by
pulling the starter two or three times,
Finally, reinstall spark plug and attach
spark plug wire.
TROUBLE CAUSE CORRECTION
Difficult sterling Stale fuel Drain fuel tank, Fill with fresh
fuel
or Defective spark plug Clean and re-gap spark plug
Clogged fuel line Replace fuel filter
Engine runs
erratic Blocked fuel line or empty fuel tank Clean fue! line; check gas tank
Carburetor outof adjustment Have carburetor adjusted
Fouled spark plug Clean and adjust gap
Crogged air Cleaner Tap clean or replace air cleaner
Jammed due to foreign object Clear obstruction
Cutting blade .......................
falls to turn Loose blade Tighten blade retaining nut
Defective belt Replace V-belt
Defective quill bearings i Replace the bearings
• =
Blade falls to cut Damaged or worn blade Reverse blade +or replace brade
properly
., Stop engine immediately; tighten
vibration alt bolts,_If vibrationcontinues,
take the unit into the nearest
Sears Service Center