Troubleshooting Chart - Craftsman 358.796500 Operator's Manual

TROUBLESHOOTING CHART
SYMPTOM CAUSE REMEDY
Blade stops
under a load
or does not
turn when
switch is
pressed.
• Forcing blade into material.
• Blade guard clogged with debriE
• Edge guide bent toward blade.
• Unit unplugged.
• Fuse blown/circuitbreaker off.
• Wom spring washer.
• None of the above.
• Cut at a slower pace.
'.,Clean blade guard area.
;• Replace edge guide.
• Plug unit into a 120 volt outlet
• Replace fuse/reset breaker.
• Replace spring washer.
• Contact your SEARS Service
Center/Dept.
Blade turns •Wheel depth incorrect. ,Adjust wheel to proper depth.
but will not cul • Incorrect or worn blade. • Replace blade.
• Worn spring washer. • Replace spring washer.
Edger drags ,Wheel depth incorrect. •Adjust wheel for proper depth.
ground or ,Wheel mount(s) broken. •Contact your SEARS Service
cuts too Center/Dept.
deep.
10