Table of Contents
Advertisement
Available languages
Available languages
Z ¸
A,
Yo urO ven Tempera ture
The temperature in the oven has been pre-set at the factory. When first using the oven, be
sure to follow recipe times and temperatures.
If you think the oven is too hot or too cool, the
temperature in the oven can be adjusted. Before adjusting, test a recipe by using a
temperature setting that is higher or lower than the recommended temperature. The baking
results should help you to decide how much of an adjustment is needed.
Note: Theoven
temperature adjustments
made with this feature will
not change the Self-Clean
cycle tern peratu re.
INSTRUCTIONS
To
adjust
the
oven
temperature
higher:
1.
Press
for 6 seconds (Fig. 1).
2.
To increase the temperature use the number pads to enter the
desired change, (Example 30°F) _(_)
(Fig. 2). The
temperature may be increased as much as 35°F (19°C).
3.
Press_
to accept the temperature
change and the display
will return to the time of day (Fig. 3). Press _
to reject the
change if necessary,
To
adjust
the
oven
temperature
lower:
1.
Press
for 6 seconds (Fig. 4).
2.
,
PRESS
©
DISPLAY
Fig. 1
Fig. 2
To decrease the temperature use the number pads to enter the
desired change. (Example-30°F)
(_)(_)
and then press
_
(Fig. 5). The temperature may be decreased
as much as
35°F(19°C).
Press _
to accept the temperature
change and the display
Fig. 3
Fig. 4
Fig. 5
will return to the time of day (Fig. 6). Press _
to reject the
©
change if necessary.
Fig. 6
Oven
Light
Win
Holder
Changing
the Oven Light
The oven light bulb is located at the rear of the oven and is covered with a glass shield held by
a wire holder. The glass shield must be in place whenever the oven is in use.
To replace the oven light bulb:
1.
Turn electrical power off at the main source or unplug the range.
Press wire holder to one side to release the glass shield.
Replace bulb with a new40 watt appliance bulb.
Replace glass shield over bulb and snap wire holder into place.
Turn power back on again at the main source (or plug the range back in).
The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer,
Be sure the range is unplugged and all parts are COOL before replacing oven
light. Wear a leather-faced glove for protection against possible broken glass.
34
Advertisement
Table of Contents
