Frigidaire FRS12PYW10 Use & Care Manual page 44

long time or during first use of the unit.
A peculiar smell comes out from the indoor unit.
This is because the indoor unit gives off smells permeated from building
material, furniture or smoke.
The air conditioner turns to FAN only mode from COOL or HEAT (Only
for models with heating function) mode.
When indoor temperature reaches the temperature setting on air conditioner,
the compressor will stop automatically, and the air conditioner turns to FAN
only mode. The compressor wilt start again when the indoor temperature rises
in COOL mode or falls in HEAT mode (Only for models with heating function)
to the set point.
Dripping water condenses on the surface of indoor unit
Dripping water may generate on the surface of the indoor unit when cooling in
a high relatively humidity (relative humidity higher than 80%). Adjust the
horizontal louver to the maximum air outlet position and select HIGH fan
speed.
Heating mode (Only for models with heating function)
The air conditioner draws in heat from the outdoor unit and releases it via the
indoor unit during heating operation. When the outdoor temperature falls,
heat drawn in by the air conditioner decreases accordingly. At the same time,
heat loading of the air conditioner increases due to larger difference between
indoor and outdoor temperature. If a comfortable temperature can't be
achieved by the air conditioner, we suggest you use a supplementary heating
device.
Auto-restart function
Power failure during operation will stop the unit completely.
For the unit without Auto-restart feature, when the power restores, the
OPERATION indicator on the indoor unit starts illuminating. T o restart the
operation, press the ON/OFF button on the remote controller. For the unit with
Auto-restart feature, when the power restores, the unit restarts automatically
with all the previous settings preserved by the memory function.
Lightning or a car wireless telephone operating nearby may cause the
unit to malfunction.
Disconnect the unit with power and then re-connect the unit with power again.
Push the ON/OFF button on the remote controller to restart operation.