Unpcking And Checking Contents; Table Of Loose Parts; Preassembly - Craftsman 113.23100 Owner's Manual

unpacking and assembny
UNPACKING AND PREASSEMBLY
WARNING: DO NOT CONNECT THE POWER CORD TO
A SOURCE OF POWER. THIS CORD MUST REMAIN
UNPLUGGED WHENEVER YOU ARE WORKING ON
TH E SAW.
Your Craftsman 1e-inch Radial Saw is shipped complete in
one carton. Cabinet and goose neck tamp are optional
accesscories.
Unpacking and Checking Contents
Separate all "loose" parts from packaging materials and
check each item with "Table of Loose Parts" to make
sure all items are accounted for, before discarding any
packing material°
If any parts are missing, do not attempt to assemble the
radial saw, plug in the power cord, or turn the switch
on until the missing parts are obtained and are installed
correctly.
Key No.
(Fig, t)
1
2
3
4
5
6
7
8
Table of LooseParts Qtyo
BasicSaw assembly ...................... 1
Reartable ................................ I
Table spacer ............................. 1
Rip fence .............................. t
Front table ............................. I
Channel,Table Mtg....................... 2
"Owner's Manual" . ...................... 1
Loose PartsCarton (containing the
following items):
Hex-"L" Wrench, I/8"o .................... 1
Hex-"L" Wrench, t/4 .................... t
Hex-"L" Wrench, 3/16 .................... 1
Elevation crankassembly ................. 1
Swivel LatchPin Knob .................. t
Switch key ............................. 2
Arbor Wrench .......................... 1
Table clamp ............................. 2
4
5
Rip-scaleindicator ........................ 2
Twin nut (for attaching rip-scaleindicator) ., 2
Machinescrew,pan÷hal.r, !/4-20 x t" o...... 6
Washer,steel(flat), 17/64 x 5/8 x 1/32". .... 7
Machinescrew,pamhd, 6-32 x 7/16" . ...... 4
Shaft wrench ............................. t
Screw, He× Hd., 5/16-I8 x t/2 ........... 4
Loc kwasher, 5/16 ...................... 4
Washer,Flat, 11/32 x 7/8 x 1/t6 ........... 4
Nut - "T". ............................ 1
Set Screw, Cup,Pt ....................... 1
Screw, PanHead, 1/4-20 x lq14 ............. 1
Nut, Speed
........... ...................
6
REMOVE SKIDS FROM BASE
MOUNT SAW TO CRAFTSMAN BASE OR
LEG SET, OR FLAT BENCH
Make sure elevation crank is free to rotate. The saw must be
bolted down° Position your entire saw (or saw bench) to
slope slightly rearward, so the carriage will not roll forward
due to gravity°