Table of Contents
Advertisement
STARTING/STOPPING THE SAW
See Figure 10,
Tostart the sam Depressthe switch trigger.
Ah_ayslet the b_adereach f,j_) speed, then gu)dethe saw
into the workp]ece.
_1_ WARNING: The b)ade comingin contact w_ththe
workp]ese before It reachesfull speed could cause
the saw to "kickback" towards you resulting in
serious personal injury.
To stop the saw: Release the switch trigger.
NOTE: Allow the blade to come to a complete stop before
removing saw from workpleoe.
WARNING; Nways unplug the toot when chang-
[ngoperation settings or when the tool is not in use.
Failure1o unplug the tool may result in accidentaK
starting and sedous persona_ Injury.
ADJUSTING BLADE DEPTH
See Figure11.,
Alwayskeepcorrectblade depthsalting. The correct
blade depth setting for al! cuts shoutd not exceed 1/4 in,
below the matefia! being cut. More btade depth wilt
increasethe chance of kickback end cause the cut to be
rough. For more depthof cut accuracy,a scale islocated
on the upper blade guard.
II Unplug the saw.
m Loosen depth adjustment knob.
i
Determinethe desireddepth of cut.
m Locate depth of cut scale on back of upper blade
guard.
aNHoldbase flat agair_._'t the workpiece and reiseor lower
saw _nti{the indicator mark on bracket alignswith
notch on blade guard°
BI Tighten depth adjusb'nentknob securely.
DEPTH OFCUT
Fig. 10
Fig. 11
15
Advertisement
Table of Contents
