Craftsman 113.197110 Operator's Manual page 73

Saw Operations - 3
Problem
Clamping force not suffi-
cient at bevel angles other
than 45 °.
Probable Cause
Bevel lock needs adjusting.
What to Do
Go to Maintaining Yb-tlr_aw7-,
Adjustments for Wear, Bevel
Lock.
Depth of cut varies from
one end of the workpiece
to the other.
Table top not parallel with arm. Go to Alignment of the Blade,
Leveling Front Table.
Blade tends to advance
through lumber too fast.
Dull blade.
Not advancing saw properly.
Replace or sharpen blade.
Draw saw blade across lumber
with a slow and steady pull.
Table cannot be leveled.
(Right side is higher than
left side with no adjustment
left, or vice versa.)
Column support shifted where it
mounts to saw base.
Loosen the six bolts that hold
the column support to the saw
base and shift arm.
73