Craftsman 113.197110 Operator's Manual page 19

Fro Bolt
Table Support
Rear Bolt
Fig. 40
14. Mark the point on the ruble support un-
der the center of the arbor shaft. (Figure 40)
15. Place the arbor wrench over this point.
(Figure 41)
16. Slide the front end of the table support
up or down until the handle end of the arbor
wrench just fits between this point and the
arbor shaj?+ The wrench should slide back
and forth with slight contact.
17. Tighten the bolt under this point using a
1/2 inch wrench.
18. Repeat steps 13-17 with the arbor shaft
over the front and rear bolts on the right table
support. Slide the rear end of the table sup-
port up or down when the arbor shaft is over
the rear bolt (see step 16).
19. Move the arbor shaft over all four points
again.
20. Place the arbor wrench over each point and
make sure that the arbor shaft just touches the
wrench. The wrench should slide back and forth
with slight contact.
If the arbor wrench will not fit between the
arbor shaft and the table support _t any point
repeat steps 8-21 until the table suppofls"are
level, or
If there is a gap between the arbor wrench
and the arbor shaft at any point, repeat steps
8-21 until the table supports are level.
h
L._[._/4J _ Front Bolt
Rear Bolt \
Table Support
Fig. 41
21. If the arbor shaft just touches the arbor
wrench at each point, go to the next section,
OF
19