Eureka 2500 Series Owner's Manual page 9

III. HOW TO PREPARE THE CARPET SHAMPOOER/EXTRACTOR
FOR CARPET CLEANING
IMPORTANT: For best results, begin with a clean surface by vacuuming surface or item before using the
carpet shampooer/extractor.
NOTE: Familiarize yourself with the parts of the
carpet shampooer/extractor by reading this
owner's manual before using.
Carrying
Handle
Tank Latch
NOTE: When moving the carpet shampooer/extractor from one location to another, always make sure the recovery
and clean water solution tanks are completely empty. Then tilt the unit slightly backward and roll on rear wheels
or use the carpet shampooer/extractor's carrying handle for transporting up and down stairs.
A. Fill the Clean Water Solution Tank
1) Lift up the tank latch to release the clean water solution tank.
2) Grasp the carrying handle on the clean water solution tank and
remove it from unit.
3) Remove cap and add 4 ounces of Genuine Eureka carpet/
upholstery shampoo to the tank.
4) Fill tank to the designated fill line with warm tap water, not to exceed
120°F, replace cap (see diagram).
5) Place clean water solution tank into the carpet shampooer/
extractor unit by
a) slightly tilting the tank top away from unit
b) place the bottom of tank into the reservoir.
c) gently push upper portion of tank into unit until it snaps
Lift
Latch
NOTE: Mix cleaning solution properly to avoid
damage to carpet and upholstery.
securely into place.
4)
Fill Line -
1 Gallon
9