Eureka 2500 Series Owner's Manual page 15

How to Use the Carpet Shampooer/Extractor
for Upholstery and Stair Cleaning
Solution
Release
Trigger
NOTE: If the cleaning solution and water are not released from the upholstery/stair nozzle, there
may be an air lock. With unit in the Off position, raise the attachment handle above your
head. Then engage the attachment handle trigger for 4 seconds. Turn unit On to resume
spraying.
NOTE: If you should encounter a clog in the Upholstery/Stair Nozzle Filter:
1) Remove the "M" shaped piece on the underside of the
Upholstery/Stair Nozzle (Use a small screwdriver to
pry loose).
2) Clear and rinse any debris from the "M" shaped piece
by placing it under running water.
3) Replace the "M" shaped piece into the solution tube
then position and lock the piece into place.
(Continued)
C. Place the Upholstery Nozzle at the top of the cleaning area.
D. Pull up and hold the solution release trigger and pull the nozzle
backward at a moderate pace.
E. Release the trigger at the end of the stroke.
F. Lift nozzle and start again at the top. Apply one to three
spraying strokes. Avoid over-soaking the area.
NOTE: As the nozzle moves over the surface, the cleaning
solution sprays onto the surface. At the same time
the nozzle picks up the dirty water and places it in
the recovery tank.
G. Move the nozzle over the surface several more times without
engaging the trigger. This removes excess water and helps
the surface dry faster.
H. Brush roll does not rotate when cleaning in the attachment
mode.
Solution Tube
Trigger
"M" Shaped Piece
15