90° Position - Craftsman Contractor 113.29884 Owner's Manual

BLADE TmLT, OR SQUARENESS OF
BLADE TO TABLE
When the bevel pointer is pointing directly to the "0"
mark on the bevel scaie, the sawblade should make a
SQUARE cut 90° to the table.
90° POSiTiON
To check for SQUARENESS:
WARNING: For your own _fe_y, turn switch
"OFF" arid remove p_ug from power $o_rce out=
_et°
1. Raise blade aii the way UP..oraise blade guard.
2. TILT blade a few degrees to the LEFT_.nowtilt blade
back to the RIGHT as far as it will go.
3. Place the square against the blade. Make sure
square is not touching the TiP of one of the saw
TEETH.
4. Operate the tilt-lock handle (COUNTER-
CLOCKWISE) to loosen the titt ctamp screw.
5. NOTE: Handle is spring loaded for engagement
with screw head - must be pushed inward for
disengagement whenever necessary to obtain a
new grip on screw head.
"_ SCREW
LOCK HANDLE
6. Rotate tilt handwheel CLOCKWISE a few turns
to tilt blade. Now rotate handwheel
COUNTERCLOCKWISE until it stops. Blade
should now be square with table and pointer
should point to "0".
If otade s SQUARE to table
A. Check pointer
F POINTER DOES NOT point to the "0" mark on the
oevel scale;
A. Remove Elevation Handwheet.
B. Loosen screw and adjust 13ointer . . . using
medium screwdriver.
C. Install Elevation Handwheet
POINTER AT
"0" POSITION
ADJUS-FtN
SCREW
55