Installing Belt Guard - Craftsman Contractor 113.29884 Owner's Manual

8. Lower the blade...install belt on saw pulley and
motor pulley.
9. Sight along edges of both pulleys and move motor
pulley so that belt is parallel to the edges of both
pulleys.. ,tighten the set screw in the motor pulley.
10. iMPORTANT: Measure the distance from end of
motor shaft to pulley... ,mark this dimension down;
you will need it later when reinstalling the pulley.
11. Make sure blade is 90 ° to table,,, raise it all the way
up.
12. Lift motor until edge of washer (see illustration) is
even with end of slot. In this position, pull motor
toward you (pins will slide in the cradle) until belt is
TIGHT., ,make sure washer is still even with end of
slot...tighten lhe two MOTOR BASE CLAMPS
SCREWS.
PINS
MOTOR BASE
CLAMP SCF_ EWS
WASHER
EDGE OF WASHER
EVEN WiTH EEND
OF SLOT
13. Put your hand around the belt half way between
the two pulleys and squeeze belt until two sides
of belt touch. The motor should move freely as
you squeeze the belt. If motor does not move
freely,belt tension must be readjusted.
!
iNSTALLiNG BELT GUARD
1. From loose parts find:
1 Belt Guard Support Bracket
1 Belt Guard Support
1 Belt Guard
2 Self Threading Screws. 10-32 x 1/2 in. long
BELT GUARD
SUPPORT BRACKET
BE_ GUARD
BELT GUARD SLJF::_PORT
!/2 IN SELF THREADING
SCREW
33