Craftsman Contractor 113.29884 Owner's Manual page 47

USUNG FEATHERBOARDS FOR THRU-
SAWRNG
Featherboards are not employed for thru-sawing opera-
tions when using the miter gauge.
Featherboards are used to keep the workpiece in con-
tact with the fence and table as shown, and to heRpstop
kickbacks.
Add 7-1/2 inch high flat facing board to the fence, the full
length of the fence.
Mount featherboards to fence and table as shown so that
_eading edges of featherboards will support workpiece.
WARNING: Make sure the feath_rboard against
the edge presses enly on the uncut po_lon (for°
ward of the blade). _t m_ght othe_lse pinch the
bBade In the ke_ and ¢au_ a kickback.
Before starting the operation (switch "OFF" and cutter
below table surface}:
(a) Install featherboards so they exert pressure on the
workpiece; be positive they are secure, and
(b) Make su re by trial that the featherboards wiil stop a
kickback if one should occur.
/
/
"C" CLA_PS /
/
/
FEATHERBOARD
WORK SUPPORT
ATHERBOARD
J
/
47