Ip Trunk Card Self-Tests - Nortel 1000 Fundamentals

Table 65
Operational Measurement command
Command
resetOM
Table 66
DCHIP-only commands
Command
DCHenable
DCHdisable
DCHestablish
DCHrelease
DCHstatus
DCHmenu
dchipResTableShow

IP trunk card self-tests

During power-up, the IP trunk card performs diagnostic tests to check
correct operation. Use the faceplate RS-232 port on the IP trunk card to
monitor these tests. IP Trunk 3.01 (and later) sends messages indicating
the completion of each phase of testing and any detected faults, to this port.
Copyright © 2007, Nortel Networks
.
Description
This command returns all Operational Measurement parameters
collected since last log dump, including:
• outgoing calls tried
• outgoing calls completed
• incoming calls tried
•
total voice time
• total fax time
• outgoing packets discarded
• incoming packets out–of–sequence
•
average packet delay
• average packet loss
• number of Fallback-to-PSTN calls
Description
Enable the DCH application on the card.
Disable the DCH application on the card.
Establish the DCH link when it is in release mode.
Release the DCH link when it is in establish mode.
Display the DCH application state.
This command allows the user to access the UIPC Debug Menu.
Once in passthru mode, the user has to "exit" the Debug Menu,
before issuing any other ITG Shell Commands.
Available from ITG shell. Show the Followers associated with
a DCHIP.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
IP trunk card self-tests 407