Craftsman 113.213130 Owner's Manual page 4

_:_ Dum NEVER be operated on
ths dd pi'e_ at a _ed g_eater than t800
RPM
c Do _ot inStait o_ ,,,_seany driP!that exceeds 7" in
engt_ 0 e×te_tds 6!t'below the Chuck aws. They
car_ S_dden_y be_d outward o_ break,
d Do not Use Wire wheets, _outer bits shaper cut-
ters circle ffly}: cutters Or rotary ptaners on this
1!_ Note and Follow the Safety Warnings and In-
structions that Appear on the Panell on the Left
Side of the Head:
FOR YOUR OWN SAFETY:
Know This Toot! Read and Understand Owner's _anuai before Using this Machine.
Use Recommended Drill Speed_See Chart inside Puitey Cover.
= Always wear safety goggles that comply
with ANSI Z87,1.
m Do not wear gloves, necktie or loose
clothing, Tie back long hair.
m Securely clamp work to table if it is too
short to contact the column when in
operating position.
a Securely took head and support to column,
arm to support, and table to arm before
operating drill press.
m Use only recommended accessories.
12, Th_s Dd_t Press has 5 speeds as hsted below:
500 RPM
990 RPM
1500 RPM
2250 RPM
3100 RPM
See inside of belt guard for specific p_acernent of
beit on puiteys
t3. Think Safety. Safety is a combination of operator
common sense and alertness at all times when the
dr_li press is being used.
WARNING: DO NOT ALLOW FAMILIARITY (GAINED
FROM FREQUENT USE OF YOUR DRILL PRESS)
TO BECOME COMMONPLACE. ALWAYS RE-
MEMBER THAT A CARELESS FRACTION OF A
SECOND tS SUFFICIENT TO INFLICT SEVERE
INJURY.
The operation of any power tool can result in foreign
objects being thrown into the eyes. which can result Rn
severe eye damage. Always wear safety goggles corn-
p!y with AK_S! Z87 1 (shown on Package) before corn-
rnencing power tool operation. Safety Goggles are
avai!able at Sears retail or catatog stores.