Desa CGG3324N Owner's Operation And Installation Manual page 15

OWNER'S MANUAL
OPERATING
HEATER
Continued
l TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
I. Turn control knob clockwise
to the OFF position.
Shutting Off Burners Only (pilot
stays lit) A.
1. Turn control knob clockwise
to the PILOT position.
B.
THERMOSTAT
CONTROL OPERATION 1
The thermostat control knob can be set to
any comfort level between Hi and Lo.
The thermostat will gradually modulate
the heat output and flame height from
higher to lower settings, or pilot, in order
to maintain the comfort level you select.
The ideal comfort setting will vary by
household depending upon the amount
of space to be heated, the output of the
central heating system, etc.
Note: Selecting the Hi setting with the
control knob will cause the burners to
remain fully on, without modulating down
in mo6t cases.
ll MANUAL LIGHTING ll
PROCEDURE
1. Follow steps I through 5 under Light-
ing Instructions, page 14.
2. Depress control knob and light pilot
with match.
3. Keep control knob pressed in for 30
seconds after lighting pilot. After 30
seconds, release control knob. Now
follow step 8, page 14.
Variable Manually-Controlled
Models
FOR YOUR
1
SAFETY READ
BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly, a
fire or explosion may result caus-
ing property damage, personal
injury or loss of life.
C.
D.
This appliance has a pilot which must
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
BEFORE LIGHTING smell all
around the appliance area for gas. Be
sure to smell next to the floor because
some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL
GAS
• Do not try to light any appliance.
• Do not teuch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow
the gas supplier's instructions.
• If you cannot reach your gas sup-
plier, call the fire department.
Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn
by hand, don't try to repair it, call a
qualified service technician or gas
supplier. Force or attempted repair
may result in a fire or explosion.
Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to
inspect the appliance and to replace
any part of the control system and
any gas control which has been un-
der water.
LIGHTING INSTRUCTIONS
1
WARNING:
• If fireplace has glass doors,
never operate this heater with
glass doors closed. If you oper-
ate heater with doors closed,
heat buildup inside fireplacewill
cause glass to burst. Also if
fireplace opening has vents at
the bottom, you must open the
vents before operating heater.
• You must operate this heater
with a fireplace screen in place.
Make sure fireplace screen is
closed before running heater.
NOTICE: During initial operation
of new heater, buming logs will
give off a paper-burning smell.
Orange flame will also be present.
Open damper or window to vent
smell. This will only lasta few hours.
Note: Home owners generally prefer to
operate their heater with the chimney
damper closed. This will put all the heat
into the room. However, there may be
times you will desire the full flames of the
High heat setting but will find the heat
output excessive. You can open the chim-
ney damper (if you have one) fully or
partially to release some of the heat.
_lh WARNING: Damper handle
will be hot If heater has been
running.
1. STOP! Read the safety information,
column 2.
2. Make sure manual shutoff valve is
fully open.
3. Press in and turn control knob clock-
wise _ to the OFF position.
Ignitor Button Control Knob
Figure 22 - Control Knob and Ignitor But-
ton Location
Continued
10_4_4 15