Assembling Steel Legs; Mounting Saw - Craftsman 113.298722 Owner's Manual

ASSEMBLRNG STEEL LEGS
1. From among the loose parts, find the following hard-
ware:
© G
114 IN EXTERNAL 1/4-20
LOCKWASHER HEX NUT
*24 Truss Head Screws, 1/4-20 x 1/2" long
*24 Lockwasher, 1t4 External
*24 Hex Nuts, 1/4-20
*8 Hex Nuts, 3/8-16
*4 Leveling Feet
Items marked with an asterik (*) are shown actual size.
114-20 x 1/2 IN.
TRUSS HEAD SCREW
318-16
2. Assemble the legs as shown.
insert the Truss Head Screws through the holes in the
legs, then through the holes in the Stiffeners. MAKE
SURE THE SCREWS GO THROUGH THE HOLES
IN THE SIDE STIFFENERS MARKED "X".
3. Install the Iockwasher, screw on the nuts but do not
tighten until completely assembled.
4. Install Leveling Feet.
HEX NUT LEVELING FOOT
ASSEMBLE SCREWS
THROUGH HOLES
MARKED"X"
SIDE STIFFENER
END
STIFFENER
IN. HEX NUTS
MOUNTING SAW
1. From among the loose parts, find the following hard-
ware:
*4 Hex Head Screws, 5/16-18 x 1ol14"!ong
*4 Hex Nuts, 5t16-18
*4 Lockwasher, 5/16 External Type
*8 Flat Washers, 11/32x 11/16 x 1/16
Items marked with an astedsk (*) are strewn actual size.
WARNING: The saw Is heavy. To avoid back
Injury, get help to lift the saw. Hold the saw close
t
to your body. Bend your knees so you can lift with
your legs, not your back.
HEX HEAD SCREW
Q
5116 IN EXTERNAL
LOCKWASHER
5tt6-18
HEX NUT
FLAT WASHER
!1