Tilt Mechanism - Craftsman 113.298722 Owner's Manual

adjustments
C. If blade is NOT SQUARE to table.., the 90 ° Stop
Screw must be ADJUSTED,
1. Unscrew 90 ° Stop Screw three to four turns
using 3/16 inch Hex "L"wrench.
2. Turn Tilt Handwheel clockwise one turn, then
tum Handwheel counterclockwise until blade is
square with table.
3. Screw 90° Stop Screw IN until it stops. Check
once again for squareness and readjust screw,
necessary.
45o Posrrtion
TILT blade to LEFT as far as it will go.
1. Place an ACCURATE square against blade. Make
sure square is not touching the TIP of one of the saw
TEETH.
If blade is 45 ° to table;
1. Check Pointer.
!
!
/
Q
90 °
STOPSCREW
\
\
\
\
If blade is NOT 45 oTO TABLE... STOP SCREW and
SCALE must be ADJUSTED.
1. LJnscrew 45 = Stop Screw three to fourturns using
3/16 inch setscrew wrench.
2. Turn Tilt Handwheel until bladeis45 oto the table.
3, Screw 45 ° Stop Screw IN untilil stops. Check once
again and readjust screw, if necessary.
!
!
©!
45 °
STOPSCREW
\
\
\
\
\
\
If POINTER DOES NOT point to the 45 ° markon the
scale;
1. Remove Elevation Handwheel.
2, Loosen two screws on Scale and adjust Scale until
Pointer points to 45 ° mark,
3. Install Elevation Handwheel.
o
TILT MECHANISM
The Handwheel shou
TILT HANDWHEEL
ADJUST THESE
TWO SCREWS
42