Craftsman 137.217100 Owner's Manual page 6

PROHIBITED ACCESSORIES
Use only accessories recommended for this shaper/router.
Follow instructions that accompany accessories. Use of
improper accessories may cause hazards.
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious injury.
UNPACKING AND CHECKING CONTENTS
To avoid injury from unexpected starting or electrical shock.
do not plug the power cord into a power source receptacle
during unpacking and assembly. This cord must remain
unplugged whenever you are working on the shaper/router
1. Carefully unpack the shaper/router and all its parts.
and compare against the illustration on page 7.
2. Place the tool on a secure surface and inspect
carefully.
RECOMMENDED ACCESSORIES
Visit your Sears Hardware Department or see the
Craftsman Power and Hand Tools Catalog to purchase
recommended accessories for this power tool.
To avoid the risk of personal injury, do not modify this
power tool or use accessories not recommended by Sears
If any part is missing or damaged, do not plug the
shaper/router in until the missing or damaged part is
replaced, and assembly is complete. To avoid electrical
shock, use only identical replacement parts when
servicing double insulated tools.
TABLE OF LOOSE PARTS
ITEM DESCRIPTION QUANTITY
A. Shaper/Router 1
B Miter gauge 1
C Fence backstop t
D. Wooden boards 2
E. S'iding fence bracket t
F. Guard assembly 1
G Lock knobs (2 short - 2 long) 4
H. Washers (large opening, flat) 5
t. Washers (small, flat) 2
J Hex. nuts 4
K. Screws (flat head phillips) 4
L. Dust chute 1
M. Table insert 1
N. Shaper spindle 1
O Collars 5
P Keyed washer 1
Q Hex nut 1
R Router nut (targe& small hole) 1
S Starting pin 1
T. 1/2" Collet 1
U. 1/4" Collet 1
V. Shaper nut (large & large hole) 1
W Wrenches (open end) 2