Procedure - HP StorageWorks NAS b2000 - v2 Quick Start Manual

Procedure

To initialize the NAS b2000 v2 using the WebUI configuration application:
1. Connect the Ethernet cables to the respective network ports of the
2. See
3. Verify that the Windows-based PC client is connected to the same subnet as
4. Power on the Windows-based PC and wait until the operating system has
5. Insert the RapidLaunch CD into the DVD-ROM drive.
6. The RapidLaunch CD should automatically run. If the program does not start
7. Go to the NAS device and power it on. It will be several minutes before the
8. Return to the Windows-based PC. Select HP StorageWorks NAS from the
NAS b2000 v2 Quick Start Guide
Caution: Do not power up the NAS device until steps 1 through 5 are
completed.
NAS b2000 v2 and the corresponding network segments, in accordance with
the information in the "Configuration Information" section in Chapter 2.
Figure 5and Table 4
NAS b2000 v2.
the NAS b2000 v2.
completely loaded.
up automatically, the program may be run manually. Click Start, then select
Run on the Windows taskbar, and then type the following:
{CD ROM drive}:\setup.exe
Wait for the interface to start up.
NAS device is accessible on the network.
Show drop down list to have RapidLaunch list all NAS devices on the
network, as shown in
for the locations of the network ports on the
Figure 6.
Configuration Setup
31